Join Date: Apr 2008
Settings for Infinity tss 1200 sub with Denon 3808
I am sorry in advance if there is a similar thread elsewhere on this board. I am new here and I seek help.
It has been 17 years since I bought a new receiver so I am at a loss when it comes to the technology of the 3808.
I have a ton of questions but I will start here. I am trying to figure out the proper setting on the back of my sub woofer so it will calibrate correctly with the mic. I have a powered sub that came with my Infinity tss 1200 speaker set.
On the back of the sub it has the following:
LFE or Normal switch
Phase switch: either 0 or 180
Crossover frequency: 50hz-150hz
Line level in: either L or R
This will sound really silly but does the 3808 have LFE? I would imagine that it does. Should I use the L or R line level in. Also what should I set the LFE switch and the Phase switch to?
The sub cable is plugged into the "SW" port on the back of my 3808. Any direction would be very appreciated-thx
|1200, 3808, calibration, denon, en, infinity, lfe, lfemain, receiver, setup, speakers, subwoofer, ts1200, tss, tss1200, tsssub|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Setting up the 3808 with D*TV HR20 and PS3||clemdogood||Receivers||1||04-11-2009 04:38 PM|
|Home Installer & Infinity Cascade Speakers||sholden125||Video Processors, Technology & Calibration||0||05-11-2008 04:47 PM|
|Denon 3808 video probs???||andytk5||Receivers||10||04-01-2008 06:58 PM|
|Denon goes Blu!||TheMoose||Blu-ray Players||2||08-03-2007 08:43 AM|
|How much better or worse is the Denon 3910 than the Denon 2900 - Find out||AVRevForum.com||Source Components||0||07-23-2007 06:39 PM|