Audio Video Revolution Forum - View Single Post - Question about Using a Y cable on two surround backs

Lefisc · 07-24-2009

I technically have a 6.1 System, with two surrounds and one back coming out of a Levinson 502.

I would like to change the set up a bit and combine, using a “Y” cable the two BACK (not surround) outputs so I could use the 7.1 settings.

I like to see if it sounds better.

Could I cause damage to the amp? Or anything? That is two outputs are going into one input, but I would monitor the sound level.

(Note: I don’t hear a huge difference between Dolby or DTS 5.1 and the HD signals. My dealer says you might hear a greater difference with a 7.1 setup. I am using a LPCM from my Pioneer Elite 09.

07-24-2009	#1
Lefisc Member Join Date: Aug 2008 Location: Wakanda Posts: 57	Question about Using a Y cable on two surround backs I technically have a 6.1 System, with two surrounds and one back coming out of a Levinson 502. I would like to change the set up a bit and combine, using a “Y” cable the two BACK (not surround) outputs so I could use the 7.1 settings. I like to see if it sounds better. Could I cause damage to the amp? Or anything? That is two outputs are going into one input, but I would monitor the sound level. (Note: I don’t hear a huge difference between Dolby or DTS 5.1 and the HD signals. My dealer says you might hear a greater difference with a 7.1 setup. I am using a LPCM from my Pioneer Elite 09.