View Single Post
Old 05-19-2008   #32
anm
Member
 
Join Date: May 2008
Location: Delhi, India
Posts: 26
Default Re: Pairing Amps with Speakers

Specific question
Will this amp be able to support speakers like JBL Studio L series L890 for fronts, LC2 for center and L810 for surrounds?

Rated Output Power
North American (FTC):
(FL, FR, C, SL, SR)100 watts minimum continuous power
per channel, 8 ohm loads, at 1 kHz, with
a maximum total harmonic distortion
of 1%
(Subwoofer) 105 watts minimum continuous power
per channel, 8 ohm loads, at 80 Hz, with
a maximum total harmonic distortion
of 1%
(FL, FR, C, SL, SR)115 watts minimum continuous power
per channel, 6 ohm loads, at 1 kHz, with
a maximum total harmonic distortion
of 1%
(Subwoofer) 125 watts minimum continuous power
per channel, 6 ohm loads, 1 channel
driven at 80 Hz, with a maximum total
harmonic distortion of 1%
European (IEC): 6 ch × 110 W at 6 ohms, 1 kHz, 1ch driven
Maximum Output Power
Asian (JEITA): 6 ch × 120 W at 6 ohms, 1 kHz, 1ch driven
Dynamic Power 180 W + 180 W (3Ω, Front)
140 W + 140 W (4Ω, Front)
95 W + 95 W (8Ω, Front)
THD (Total Harmonic
Distortion) 0.9% (Power Rated)
Damping Factor 60 (Front, 1kHz, 8Ω)
Input Sensitivity and
Impedance 200 mV/ 47 kΩ (LINE)
Output Level and
Impedance 200 mV/ 470 Ω (REC OUT)
Frequency Response 10 Hz–50 kHz/ +1 dB-3 dB (Direct mode)
Tone Control ±10 dB, 80 Hz (BASS)
±10 dB, 20 kHz (TREBLE)
Signal to Noise Ratio 100 dB (LINE, IHF-A)
Speaker Impedance 6Ω– 16Ω
anm is offline   Reply With Quote